HiveComb

Hello hivers..How are you doing, i hope you all are doing great. It's a great pleasure to be posting in this community today and i will talking about how i made a little budget phone case and also share the pictures.

Procedures
Measure out the size needed on the cardboard with your pen and after marking it, you will start folding the paper alongside the four edeges and seen in the picture below

Cut open spaces for like camera, fingerprint censor, charging port with a razor.
Use the scissor to cut the four edges of that you folded earlier,then use cellotape to cover the open edges

Lastly for the design at the back, you'll write the name of your design and if you're using two paints,try to use a cello tape to dimacate so as not to make mistakes in painting.
And when you're done ,press the edges hard flat so it can balance and your phone porch is ready.

All images are mine
Thanks for reading through.